Second Phase - Run Scenario

After you have set up the basic data on the Setup page, you can go to the next phase to create scenarios.

There are two main scenarios that can be executed:

• Number of CoGs Scenario

• Drive Time Scenario

For large datasets these calculations can take some time (varying from about half a minute up to several minutes or even hours). For the drive time scenario you can influence this time by changing (some of) the Settings - Drive Time Scenario.

On Run Scenario page, the overview of the finished calculation is available, while on the Scenario Details page the user can find more information about the created CoGs.

• Arriving to page Run Scenario
  • Demand/Supply Distribution Map
  • Map Control Side Panel
    • Scenario Settings
    • View Settings
    • Decrease/increase nodes
  • Node Filter
  • Transport Filter
  • Legend Side Panel
  • Job List
  • Save Scenario Page action
• Determine Center(s) of Gravity
  • Number of CoGs Scenario
    • Algorithm to determine CoGs in Number of CoG scenario
  • Drive Time Scenario
  • Result Overview
• Scenario Details